AnchorLift Anchor Retrieving System Raise your anchor with ease! The AnchorLift Anchor Retrieving System allows you to raise your anchor with ease. Simply thread the AnchorLift onto the anchor line, power forward, and the AnchorLift will float your anchor to the surface. Will float anchors up to 80 pounds Stainless steel reinforced nylon body Acts as marker buoy for quick anchor release Works effectively with crab and shrimp pots, too Lifetime warranty How does it work? The AnchorLift uses the flotation of a buoy (not included) and the forward movement of the boat to float the anchor to the surface. The AnchorLift uses the flotation of a buoy  and the forward movement of the boat to float the anchor to the surface.

Here's how...   1. Attach a buoy to the AnchorLift. Slide the AnchorLift over the end of the anchor line, threading the line under the sliding bolt. 2. Knot the anchor line near its end. Fasten the line to your boat. 3. Release the anchor by sliding the bolt to the "up" position, allowing the anchor line to slide through the AnchorLift. To raise your anchor... 1. With the AnchorLift on your line, motor your boat forward around the anchor, taking care to keep the anchor line clear of the prop.   2. Proceed slowly (roughly 5 knots) until the anchor has released from the bottom, then increase speed slightly (6 to 8 knots). 3. The anchor line will slide through the AnchorLift and float the anchor to the surface. 4. When the anchor has reached the surface, shift into neutral and pull in the slack anchor line. The sliding bolt will lock the anchor at the surface for easy retrieval.         This listings is for the lifting device only - You will also require a Float or a 20litre oil-drum A 13" float will lift a 30lb anchor A 16" float will lift a 60lb anchor A 18" float will lift a 80lb anchor MADE IN USA